New assembly and interconnect technologies for power modules | IEEE Conference Publication | IEEE Xplore

New assembly and interconnect technologies for power modules


Abstract:

Higher operation temperatures and the current density increase of new IGBT generations make it more and more complicated to meet the quality requirements for power electr...Show More

Abstract:

Higher operation temperatures and the current density increase of new IGBT generations make it more and more complicated to meet the quality requirements for power electronic modules. Especially the increasing heat dissipation inside the silicon leads to maximum operation temperatures of nearly 200 deg C. As a result new packaging technologies are needed to face the demands of power modules in the future. In case of the chip-to-substrate interconnect basically two technology trends for an improved die attach procedure became visible. On the one hand diffusion bonding has been presented, where the joint is formed from high melting intermetallics. On the other hand the chip-to-substrate interconnect can be realized by sintering silver particles, resulting in a monometallic porous die attach layer. This paper presents a comparison of these two technology trends with respect to their applicability for power electronics packaging.
Date of Conference: 06-08 March 2012
Date Added to IEEE Xplore: 11 May 2012
Print ISBN:978-3-8007-3414-6
Conference Location: Nuremberg, Germany

Contact IEEE to Subscribe

References

References is not available for this document.