The 3D-Printed Non-Radiating Edge Gap-Coupled Curved Patch Antenna

The use of parasitic resonant patches is a widespread technique to improve the bandwidth of microstrip patch antennas. Exploiting the free form-factor allowed by 3D-printing manufacturing technology, we present here a novel curved patch antenna layout, based on the non-radiating edge gap-coupled patch configuration. The proposed antenna is composed of a central curved patch, fed by a coaxial probe, and two gap-coupled parasitic side curved patches. This solution features a percentage impedance bandwidth of 16.3% using symmetrical parasitic side patches and 31.5% using asymmetrical side patches. A significant improvement of the bandwidth in comparison with both the standard non-radiating edge gap-coupled microstrip antenna (6.1% bandwidth) and the standard curved patch antenna (9% bandwidth) is achieved. Design and optimization of the proposed configuration are performed using the commercial software CST Studio Suite at the center frequency of 2.45 GHz. Prototypes of the symmetrical curved non-radiating edge gap-coupled patch antenna have been manufactured for the experimental verification, using a curved 3D-printed polylactic acid (PLA) substrate, fabricated with the commercial 3D printer PRUSA MK3S + and a
$50\mu \text{m}$
-thick adhesive aluminum tape for the metallization. Measured results show a very good agreement with simulations.