Modified CCF Based Shunt Active Power Filter Operation With Dead-Band Elimination for Effective Harmonic and Unbalance Compensation in 3-Phase 3-Wire System

The effect of reduction in the terminal voltage of a grid-tied inverter together with minimization in total harmonic distortion (THD) of terminal voltage and current, in the presence of dead-band in the switching remains always challenging for the researchers. With high switching frequency, this issue increases by many folds. The grid-tied inverter used for harmonic compensation acts as a shunt active power filter (SAPF). The implementation of the dead-band elimination technique is based on output current polarity detection, suffers from multiple zero-crossing due to the generation of high frequency switching harmonics during SAPF operation. This paper deals with a dead band elimination methodology together with harmonic compensation using SAPF under non-linear and unbalanced loading conditions. Here, SAPF uses a dual fundamental component extraction (DFCE) scheme with modified complex coefficient filter (MCCF) to extract fundamental components for reference current generation to implement an indirect current control PWM scheme. MCCF extracts fundamental components even in the presence of dc offset and unbalancing at the input. For incorporating dead-band elimination in control, exact polarity detection is done separately through SAPF output current estimation using sensed load current, and modified CCF computed reference source current. Since the estimated SAPF output current contains no high-frequency switching harmonics, the dead-band elimination technique can be correctly implemented. To synchronize the zero-crossing of the estimated and actual SAPF current, an adaptive delay control is used. The proposed MCCF based control logic’s performance together with the dead-band elimination technique is validated for SAPF operating under non-linear, unbalance, and dynamic load conditions. The proposed dead-band elimination scheme based SAPF model is developed and simulated using MATLAB/ SIMULINK. The simulation results show a significant reduction in source current harmonics due to the elimination of odd harmonic injection into the system by incorporating dead-band elimination in SAPF operation. The real-time simulation of the proposed method is also validated using OPAL-RT OP4510 real-time platform.