Load network of the VS-DPA with the proposed design conditions.
Abstract:
The load networks of advanced Doherty power amplifiers (DPAs) have traditionally been designed according to the ABCD parameters. In this paper, design conditions as an im...Show MoreMetadata
Abstract:
The load networks of advanced Doherty power amplifiers (DPAs) have traditionally been designed according to the ABCD parameters. In this paper, design conditions as an impedance transformation condition and an effective electrical length were used to design the output matching networks (OMNs) for the carrier and peaking amplifiers of the virtual-stub DPAs (VS-DPAs). An optimization method for the effective electrical length was proposed that was specifically constructed for the load impedances of the carrier amplifier at the low power level to have broadband characteristics through the load-pull simulation. Using the optimized design conditions for broadband design, compact OMNs for the carrier and peaking amplifiers were designed using quasi-lumped components. Moreover, an asymmetric structure with an increased power capacity of the peaking amplifier for the VS-DPA was proposed to compensate for a relatively low peak fundamental current of the peaking amplifier due to its deep class-C operation as well as the extended output back-off (OBO) range of the VS-DPA. To verify the proposed load network, a broadband asymmetric VS-DPA for the 3.3 - 4.2 GHz band was designed and implemented using GaN HEMTs with power capacities of 6 and 10 W. Using a 5G new radio (5G NR) signal with a signal bandwidth of 100 MHz and a peak-to-average power ratio (PAPR) of 7.8 dB, power gain of 8.2 - 9.1 dB, DE of 46.0 - 57.0%, ACLR of better than −45 dBc after DPD linearization at an average power of 35.0 dBm were achieved at the broad frequency range of 3.3 - 4.2 GHz.
Load network of the VS-DPA with the proposed design conditions.
Published in: IEEE Access ( Volume: 11)