Control of PMSM Drive Using Lookup Table Based Compensated Duty Ratio Optimized Direct Torque Control (DTC) | IEEE Journals & Magazine | IEEE Xplore

Control of PMSM Drive Using Lookup Table Based Compensated Duty Ratio Optimized Direct Torque Control (DTC)


Illustrates the duty optimization method and torque compensation, when the red dotted line represents torque response without duty ratio optimization, the black dotted li...

Abstract:

There are several ways to reduce the ripple magnitude for direct torque-controlled permanent magnet synchronous motor (PMSM) drives. In this work, the compensated duty ra...Show More

Abstract:

There are several ways to reduce the ripple magnitude for direct torque-controlled permanent magnet synchronous motor (PMSM) drives. In this work, the compensated duty ratio optimized direct torque control (DDTC-TC) method was proposed to reduce the ripple magnitude for three-phase PMSM. The proposed control strategy employs the simplicity of conventional DTC (CDTC) and compensation of the reference torque to enforce the developed torque to oscillate around the required value. A torque error square minimization technique was employed to determine the duty ratio. Magnitude of developed torque by the PMSM depends on the torque slope during the active and null voltage periods. The slope of the torque during each period is computed online. Based on the online computed slopes, the magnitude of the switching period and compensation torque were calculated. The ripple reduction capability of the proposed control scheme is tested using Matlab Simulink and a hardware in loop system. Both experimental and simulation results indicate that the control scheme is effective. Specifically, the torque and speed ripples are very small. The torque ripple during speed fluctuation is less for open-end winding PMSM. In addition, the proposed scheme was tested for four-quadrant operation. Results for four quadrants indicate that the scheme is effective for four quadrant operation. Finally, verification of the effectiveness of the proposed scheme is performed using OPAL-RT-RT (OP4500). Verification indicates that the proposed scheme is effective.
Illustrates the duty optimization method and torque compensation, when the red dotted line represents torque response without duty ratio optimization, the black dotted li...
Published in: IEEE Access ( Volume: 11)
Page(s): 19863 - 19875
Date of Publication: 24 February 2023
Electronic ISSN: 2169-3536

References

References is not available for this document.