A Long-Pulse Generator Based on Tesla Transformer and Pulse-Forming Network

An approach for producing a long pulse up to 100 ns is presented. The generator based on this approach consists of a Tesla transformer and a set of pulse-forming networks (PFNs). The Tesla transformer is used to charge pulse-forming lines (PFLs) and PFNs which are in parallel. When the voltage increases to a certain value, the main switch will close, and the PFLs and PFNs will discharge rapidly to the load. Therefore, a high-voltage long pulse is formed on the load. The amplitude of this pulse is dependent only on the charging voltage and the matching state between the load and the PFL (PFN). The pulsewidth is determined by the transmission time of the PFL and PFN. The rise time is determined by the working state of the main switch and the impedance of the PFL and is independent of the parameters of the PFN. The PFN is multistage and assembled in series. The single-stage PFN is formed with ceramic capacitors placed between two unclosed annular plates. The total series impedance is equal to the sum of every single-stage PFN's impedance. A nine-stage PFN is used in the generator, and the total impedance is 40 Omega. Experimental results show that a high voltage of an amplitude of 300 kV, current of 6.9 kA, and duration of 110 ns is obtained at a repetition rate of 10 Hz, with a rise time of approximately 7 ns.