# IEEE Journal of Solid-State Circuits

## Filter Results

Displaying Results 1 - 25 of 26
• ### [Front cover - December 1968]

Publication Year: 1968, Page(s): f1
| PDF (48 KB)
• ### [Inside front cover - December 1968]

Publication Year: 1968, Page(s): f2
| PDF (122 KB)
• ### Editor's Notice (December 1968)

Publication Year: 1968, Page(s): 323
| PDF (55 KB)
• ### Foreword: Linear Integrated Circuits

Publication Year: 1968, Page(s): 324
| PDF (169 KB)
• ### New techniques for drift compensation in integrated differential amplifiers

Publication Year: 1968, Page(s):325 - 330
Cited by:  Papers (2)
| | PDF (964 KB)

A technique is described for achieving low-voltage offset and thermal drift in a monolithic integrated differential amplifier. First order compensation is achieved, under severe restrictions, for a simple differential pair. An alternative balancing technique utilizes the linear combination of two equal and opposite drift characteristics to minimize drift from all sources. Drift values of /spl plus... View full abstract»

• ### Some techniques for precision monolithic circuits applied to an instrumentation amplifier

Publication Year: 1968, Page(s):331 - 341
Cited by:  Papers (5)
| | PDF (1662 KB)

Precision monolithic circuit functions can be fabricated if proper circuit and processing techniques are incorporated. Compatible thin-film-on- silicon technology is coupled with annealing of individual resistors with a focused laser beam to provide a means for fabricating monolithic circuits in the 0.1 to 1.0 percent accuracy range. It is shown that special circuit techniques, which accommodate u... View full abstract»

• ### A monolithic junction FET-n-p-n operational amplifier

Publication Year: 1968, Page(s):341 - 348
Cited by:  Papers (51)  |  Patents (3)
| | PDF (1290 KB)

A monolithic operational amplifier with junction FET inputs in combination with n-p-n bipolar transistors is described. Both dc and small signal analysis of the amplifier are carried out. Electrically the devices are comparable with discrete state-of-the- art p-channel FET's. The circuits are fabricated with a process requiring a single diffusion more than standard techniques. The process is repro... View full abstract»

• ### An integrated operational amplifier with novel HF behavior

Publication Year: 1968, Page(s):348 - 352
Cited by:  Papers (1)
| | PDF (729 KB)

There is a growing demand for integrated operational amplifiers that combine high gain with a large unity-gain bandwidth and a simple frequency compensation. A frequency-compensation technique is described that enables construction of multi-stage amplifiers without introducing compensation problems. The suggested solution is based on the elimination of stages in the high-frequency region, such tha... View full abstract»

• ### A new wide-band amplifier technique

Publication Year: 1968, Page(s):353 - 365
Cited by:  Papers (190)  |  Patents (33)
| | PDF (2181 KB)

Precision dc-coupled amplifiers having risetimes of less than a nanosecond have recently been fabricated using the monolithic planar process. The design is based on a simple technique that has a broad range of applications and is characterized by a stage-gain- bandwidth product essentially equal to that of the transistors, and a very linear transfer characteristic, free from temperature dependence... View full abstract»

• ### A precise four-quadrant multiplier with subnanosecond response

Publication Year: 1968, Page(s):365 - 373
Cited by:  Papers (489)  |  Patents (89)
| | PDF (1432 KB)

This paper describes a technique for the design of two-signal four-quadrant multipliers, linear on both inputs and useful from dc to an upper frequency very close to the f/SUB t/ of the transistors comprising the circuit. The precision of the product is shown to be limited primarily by the matching of the transistors, particularly with reference to emitter-junction areas. Expressions are derived f... View full abstract»

• ### Applications of a monolithic analog multiplier

Publication Year: 1968, Page(s):373 - 380
Cited by:  Papers (29)  |  Patents (4)
| | PDF (1087 KB)

A fully balanced analog multiplier using differential transistor pairs is briefly described. Several circuit functions usually required in communication systems can be derived from the basic circuit. In particular, the different modes of operation leading to FM detection, suppressed carrier modulation, synchronous AM detection, and TV chroma demodulation are discussed. Experimental data obtained w... View full abstract»

• ### A monolithic high-power series voltage regulator

Publication Year: 1968, Page(s):380 - 387
Cited by:  Papers (5)  |  Patents (1)
| | PDF (1344 KB)

A complete series voltage regulator circuit capable of delivering /SUP 1///SUB 2/ ampere of current has been built on a single 63/spl times/66-mil die using the conventional all- diffused processing technology. Improved performance has been achieved by using an internal low-power voltage regulator to supply the desired dc output voltage reference directly to a second main regulator. This permits t... View full abstract»

• ### AC line operation of monolithic power control circuits

Publication Year: 1968, Page(s):388 - 391
| | PDF (668 KB)

The major difficulty encountered in the operation of a bipolar IC-directly from the ac line is the maintenance of back bias on the substrate isolation junction. The circuit power supply is derived by rectification of line voltage with diodes contained in the pellet. Because of the direct connection to the ac line no negative potential reference point exists and the substrate isolation junction bec... View full abstract»

• ### Temperature sensitivity of frequency of integrated oscillators

Publication Year: 1968, Page(s):391 - 396
Cited by:  Papers (7)
| | PDF (943 KB)

Temperature sensitivity of frequency of a monolithic RC oscillator can be separated into effects due to the passive frequency determining elements, the amplifier gain level, and the amplifier nonlinearity. Studies and experimental results of typical integrated oscillators indicate that accurate evaluation of performance can be obtained and lead to a method to achieve temperature compensation. A co... View full abstract»

• ### Stability considerations in monolithic integrated- circuit amplifier limiters

Publication Year: 1968, Page(s):397 - 401
Cited by:  Patents (2)
| | PDF (769 KB)

A certain correlation exists between the stability of a monolithic amplifier and to the product of the forward gain and the reverse transfer. Although a general method for determining stability cannot be given, it appears that instability problems are caused by output current rather than by output voltage. View full abstract»

• ### IF Amplifier using C/SUB c/ compensated transistors

Publication Year: 1968, Page(s):401 - 407
Cited by:  Papers (39)  |  Patents (6)
| | PDF (1193 KB)

An integrated bridge network of four transistors is used as a self-neutralized active element in tuned RLC amplifier designs. The bridge network compensates for the transistor collector-base junction capacitance (C/SUB c/), yielding a 95-percent reduction in the common-emitter reverse transmission admittance. IF amplifier stages that achieve the maximum unilateral power gain of a common-emitter tr... View full abstract»

• ### A high-performance monolithic IF amplifier incorporating electronic gain control

Publication Year: 1968, Page(s):408 - 416
Cited by:  Papers (26)  |  Patents (1)
| | PDF (1374 KB)

A direct-coupled monolithic IF amplifier that incorporates an active gain control stage and exhibits a power gain of 50 dB and an AGC range of 60 dB at 50 MHz is described. This circuit has negligible change in either input or output admittance, and has excellent signal linearity over the full range of gain control. Experimental and theoretical analyses are made of the large signal response, stabi... View full abstract»

• ### Integrated frequency-selective amplifiers for radio frequencies

Publication Year: 1968, Page(s):417 - 422
Cited by:  Papers (8)
| | PDF (1127 KB)

The design approach for integrated selective amplifiers described here is based on a feedback configuration with a positive real zero in the loop transmission function. The basic circuit consists of two unity gain amplifiers and a transconductance block with RC imbedding. Temperature- insensitive performance, with Q values up to at least 150, at center frequencies in the RF range, is obtained for ... View full abstract»

• ### Metal-oxide-semiconductor circuits of higher orders of complementarity

Publication Year: 1968, Page(s):423 - 431
| | PDF (1356 KB)

Higher orders of complementarity of MOST circuits are obtained when the devices used differ not only in the dominant charge species, such as in n-channel and p-channel units, but also in the mode of control of channel conductance, such as in depletion mode and enhancement mode. Some of these circuits in a hook' connection displayed unusual static volt-ampere characteristics, with double points.'... View full abstract»

• ### Low-noise photoparametric up-converter

Publication Year: 1968, Page(s):431 - 440
Cited by:  Papers (11)
| | PDF (1640 KB)

An analysis is given for a photoparametric up-converter system. The up-converter consists of a single triplate line with one coaxial output connected to a circulator, through which the pump is applied and the signal extracted. The other end of the line is connected to the photo diode via a small coupling capacitor. The light is modulated at frequencies from a few hertz to some upper limit determin... View full abstract»

• ### An optimized gain-control configuration using the field- effect transistor

Publication Year: 1968, Page(s):441 - 447
Cited by:  Papers (1)  |  Patents (1)
| | PDF (889 KB)

Previous automatic gain-control configurations have not provided an entirely satisfactory solution to the dilemma of maintaining a high signal-to-noise ratio (S/N) with low distortion in low Q audio applications. A gain-control configuration that provides broadband control at a relatively high signal level with low distortion is described. View full abstract»

• ### Frequency-stable tunnel diode oscillators

Publication Year: 1968, Page(s):448 - 449
| | PDF (281 KB)

From a linear analysis of a tunnel diode loaded with a transmission line, it is shown that oscillations highly stable in frequency are possible. Preliminary experimental results are in agreement with the theory. Stability on the order of one part in 10/SUP 5/ is easily attained. View full abstract»

• ### Invariant of a noisy two-port

Publication Year: 1968, Page(s):449 - 450
| | PDF (338 KB)

A recent paper (see abstr. B3611 of 1968) is extended to show the existence of a quantity associated with a noisy two-port that is invariant under lossless transformation. The transforming network may be reciprocal or nonreciprocal. View full abstract»

• ### Tunnel-diode-pair unidirectional pulse regenerating circuits

Publication Year: 1968, Page(s):450 - 451
Cited by:  Papers (3)
| | PDF (366 KB)

A method of constructing unidirectional pulse regenerating circuits with a pair of two-terminal active devices, such as tunnel diodes, is described. View full abstract»

• ### Optoelectronic circuitry for a reading aid

Publication Year: 1968, Page(s):451 - 453
| | PDF (557 KB)

A reading aid for the blind has been constructed that generates a tactile image of ordinary printing by using a rectangular array of vibratory pins. Reading material is focused on an array of phototransistors. These individually gate ON or OFF corresponding vibratory piezoelectric reeds that present the tactile image. A first model is described that verifies the unambiguous readability of typed ma... View full abstract»

## Aims & Scope

The IEEE Journal of Solid-State Circuits publishes papers each month in the broad area of solid-state circuits with particular emphasis on transistor-level design of integrated circuits.

Full Aims & Scope

## Meet Our Editors

Editor-in-Chief

Jan Craninckx
Imec
Kapeldreef 75
B-3001 Leuven, Belgium
jssc.craninckx@gmail.com