Baseband-pulse-antenna techniques

Frequency-domain concepts and terminology are commonly used to describe antennas. These are very satisfactory for a CW or narrowband application. However, their validity is questionable for an instantaneous wideband excitation. Time-domain and/or wideband analyses can provide more insight and more effective terminology. Two approaches for this time-domain analysis have been described. The more complete one uses the transfer function, a function which describes the amplitude and phase of the response over the entire frequency spectrum. While this is useful for evaluating the overall response of a system, it may not be practical when trying to characterize an antenna's performance, and trying to compare it with that of other antennas. A more convenient and descriptive approach uses time-domain parameters, such as efficiency, energy pattern, receiving area, etc., with the constraint that the reference or excitation signal is known. The utility of both approaches, for describing the time-domain performance, was demonstrated for antennas which are both small and large, in comparison to the length of the reference signal. The approaches have also been used for other antennas, such as arrays, where they also could be applied to measure the effects of mutual impedance, for a wide-bandwidth signal. The time-domain ground-plane antenna range, on which these measurements were made, is suitable for symmetric antennas. However, the approach can be readily adapted to asymmetric antennas, without a ground plane, by using suitable reference antennas.<
>