By Topic

3D optical networks-on-chip (NoC) for multiprocessor systems-on-chip (MPSoC)

Sign In

Full text access may be available.

To access full text, please use your member or institutional sign in.

Formats Non-Member Member
$33 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

6 Author(s)
Yaoyao Ye ; Electronic and Computer Engineering Department, Hong Kong University of Science and Technology, Hong Kong ; Lian Duan ; Jiang Xu ; Jin Ouyang
more authors

Networks-on-chip (NoC) is emerging as a key on-chip communication architecture for multiprocessor systems-on-chip (MPSoC). In traditional electronic NoCs, high bandwidth can be obtained by increasing the number of parallel metallic wires at the cost of more energy consumption. Optical NoCs are thus proposed to achieve low-power ultra-high-bandwidth data transmission in optical domain. Electronic control technology could be a complement to the optical networks. Besides NoCs, three-dimensional integrated circuits (3D ICs) are another attractive solution for system performance improvement by reducing the interconnect length. The investigation of using 3D IC as a platform for the realization of mixed-technology electronic-controlled optical NoC has not been addressed until recently. In this paper, we propose a 3D electronic-controlled optical NoC implemented in a TSV-based (through-silicon via) two-layer 3D chip. The upper device layer is an optical layer. It integrates an optical data transmission network, which is responsible for optical payload packets transmission. The bottom device layer is an electronic layer. It contains an electronic control network, which is used to route control packets and configure the optical network. We built an 8 times 8 mesh-based 3D optical NoC, with a 45 nm electronic control network. Power comparison with a matched 2D electronic NoC shows that the optical NoC can reduce power consumption significantly. For 2048 B packets, it has a 70% power reduction. End-to-end delay (ETE delay) and network throughput of the two NoCs under varying injection rates were evaluated for comparison. The results show that ETE delay of the optical NoC is much smaller than the electronic NoC when the network becomes congested. Take 4096 B packets for example, it is 18.7 mus in the optical NoC with an injection rate of 0.5, while 33.5 mus in the electronic one. A maximum throughput of 478 Gbps can be offered by the optical NoC using 32 Gbps optical link bandwi- dth. Because of the low resource utilization of circuit switching, the maximum throughput of the optical NoC is slightly lower than the electronic one.

Published in:

3D System Integration, 2009. 3DIC 2009. IEEE International Conference on

Date of Conference:

28-30 Sept. 2009