A Multi-Frequency 3D Printed Hand Phantom for Electromagnetic Measurements

It has been shown that the presence of a hand holding a wireless handset (cell phone) can influence antenna efficiency and the measurement of specific absorption rate (SAR) and electromagnetic compatibility. Head phantoms, used in handset compliance testing to estimate SAR in the head, have achieved low cost and multi-frequency use. Head phantoms typically consist of a thin plastic shell, open on the top, holding a tissue simulating fluid. The specific simulant fluid used is determined by the radio frequency of the test. IEC 62209–1 has recipes, using safe nontoxic materials, for all the required frequency bands. Thus, head phantoms can be reused at different frequencies simply by changing the tissue simulating fluid. However, standards have not adopted the use of hand phantoms because SAR limits in limbs are less restrictive than the head, the tissue depth in a hand is insufficient to make accurate measurements with current electric field probes, and the cost of a solid hand phantom is limited to a single frequency band. Our goal was to determine whether 3D printing techniques would allow the construction of a hand phantom with the same utility as existing head phantoms. We developed this phantom based on computer simulations to determine how much human anatomy needed to be included in the phantom to obtain results consistent with actual use. Electric field scans of a handset alone, and held by the hand phantom, were performed. Comparison of handset scans using the phantom and human subjects was planned, but not performed due to Covid-19 restrictions and subsequent changes in priorities. We feel a fluid-filled 3D printed hand phantom is viable and practical. The 3D print files are available on GitHub.