A microwave anechoic chamber for radar-cross section measurement

A microwave anechoic chamber has been developed at the Department of Electrical Engineering, University of Malaya, for monostatic and bistatic radar-cross-section measurements. The structure of the chamber is a quarter-section geodesic dome, with a 12 foot radius, and raised three feet above the floor. An antenna railing system is installed inside the chamber. The antennas can be moved along the rails in the elevation direction, with the microwave beam pointing at the center of the dome where the target is located. This design enables a very large combination of incidence and scattering angles in bistatic measurements. Four transmitting antennas are fixed at different elevation angles next to one of the antenna rails. By using an azimuth-over-elevation positioner as the pedestal for the target, and by positioning the movable antenna along that rail beside those fixed transmitting antennas, monostatic measurements with incidence angles ranging from 0 to 90 degrees can be accomplished. A vector network analyzer is utilized to measure the amplitude and phase of the radar returns. An IEEE-488.2 interface bus is used to control various hardware components, as well as to perform data acquisition. A computer program was written to automate the measurement system. Data are stored in raw format, and processed later with dedicated software, so that different processing methods and parameters can be applied. This paper highlights the design and construction of the microwave anechoic chamber, as well as the measurement-system configuration for scattering-cross-section measurements.