Decrease in ac partial discharges on insulating materials by use of dye additives

The purpose of this study is to decrease PD at a triple junction by addition of a dye to an insulating material. PD is produced on a test specimen subjected to ac voltage under a sphere-plane electrode configuration. The specimen is composed of two layers: a PMMA film with additive, which is 100 /spl mu/m thick; the lower layer a PMMA board 3 mm thick. The film with the additive was prepared by the solution-grown casting method. Five kinds of dye were used as the additive; p-aminoazobenzene (Ab), p-nitrobenzeneazoresorcinol (Nb), methyl yellow (My), methylene blue (Mb) and methyl red (Mr). In the case of the films with Ab and Mb at 0.05% wt, the magnitude and number of PD pulses were reduced to /spl sim/50% less than those in the case of the films without the additive. The decrease in PD was effective under an electric field strength slightly higher than the PD inception. In the case of the other dyes, decrease in PD was not observed. The surface voltage distribution due to the charge by PD depended on the kind of dye additive. The decrease in PD for the Ab and Mb films was explained from the dependence of the surface voltage distribution on the dye. It was concluded that ionization of the dye molecules in the film changes the distribution of surface voltage.