Optimizing wire parameters in exploding wire arrays

Exploding wire arrays as fast switches are of interest for explosive pulsed power applications utilizing magnetic flux compression. This type of opening switch has proven effective in producing pulses of several hundred kilovolts into vacuum diode loads. The research presented here discusses an exploding wire array capable of producing single digit kilo-joules, 100 nanosecond pulses when driven by a 45 kilo-Amp current with a waveform closely resembling typical magnetic flux compression output. For this specific parameter range, the optimal fuse design was developed based on the experimental behavior of the fuse under variation of parameters such as wire spacing, shielding, and quenching medium. Each fuse is composed of several silver wires arranged in a straight wire cylindrical array and is typically pressurized in a chamber filled with about 0.6 MPa of SF
₆
. The tradeoff between wire spacing and voltage output was addressed by designing four different fuse termination pairs each with a diameter that increased wire spacing from 5 to 20 mm in 5 mm increments. A wire shield test was also conducted as an extension to the wire spacing experiment to uncover any mutual radiative effects between wires on fuse opening behavior. The optimum fuse design, including the optimum fuse wire diameter, will be discussed with a 20 Ohm resistive load as well as a vacuum diode load with similar impedance.