Cathode Surface State and Cathode Temperature Distribution After Current Zero of Different AMF-Contacts

The objective of this paper is to compare the state of cathode surface of different axial magnetic field (AMF) contact systems (CSs) during arcing and after arc extinction. The arcs were ignited by opening of electrodes and were fed by sine half-wave current pulses with a duration of 10 ms. Investigations were performed in the range of arc currents up to the levels of guaranteed failure. The measurements were done by a high-speed Phantom M310 video camera. The cathode surface state during arcing was studied using a set of neutral density filters. It was discovered that melting of a part of the cathode surface during arc burning takes place in high-current vacuum arcs. A changing relief in the form of hillocks and hollows forms on the melted surface. We found out that there are two components in droplet erosion of the cathode, when its surface is partially melted: in addition to droplets formed directly in the cathode spot (which can be called droplets of the first type), the liquid part of the surface also emits droplets (which can be called droplets of the second type) significantly different in their sizes and velocities. The formation mechanisms of droplets of the first and the second type are different. The cathode surface temperature distribution immediately after current zero was obtained by comparing the results of cathode surface filming to the results of calibrated band-lamp filming in identical conditions. Reflection of anode radiation from cathode surface was analyzed by mathematical simulation. The filming was carried out using an interference filter. We found that the distribution of the cathode surface temperature is substantially nonuniform. The axial region is the most heated. We conclude that in all investigated CSs with the same amplitude value of the current, the temperature of the most heated parts of the cathode surface is significantly lower than the temperature of the most heated parts of the anode surface. Analysis of obtained results shows that switching failure can be provoked by the cathode and by the anode processes depending on CS design.