Ethernet Packet Transformation and Transmission Between Modbus/TCP and USB 3.0 with Field-Programmable Gate Array Development Board

This paper presents an Ethernet packet transformation and transmission architecture between Modbus transmission control protocol (Modbus/TCP) and universal serial bus (USB) 3.0 developed with a field-programmable gate array (FPGA) development board. The proposed architecture is used to complete packet transformation and transmission between Ethernet and USB 3.0 for application in plant automation. The Ethernet receiver receives and analyzes Modbus/TCP packets and sends the source address, destination address, IP header, and Modbus/TCP header to the register to verify the correctness of the packet. The Modbus/TCP packet is stored in static random access memory and awaits access by a USB 3.0 module. An FPGA development board (Intel DE10-Standard) is used for functional verification. The measured results show that the latency, throughput, and dynamic power are 18.845 ×s, 747.45 Mbps, and 142.17 mW, respectively, at a voltage of 1.8 V and operating frequency of 125 MHz.