Understanding Effects of Deep Traps on DC Surface Flashover Characteristics of Epoxy/MWCNTs-TiO2 Nanocomposites in a Vacuum

Surface flashover is likely to be triggered when a high electric field is applied due to its voltage being much lower than the breakdown voltage of either gas or solid, which restricts the development of advanced power electrical and electronic devices. To improve dc surface flashover performances in a vacuum and further explore the effects of deep traps on surface flashover, conductive multiwall carbon nanotubes (MWCNTs) and nonconductive nano-titania (TiO2) particles were incorporated into the epoxy (EP) matrix to tailor the surface deep trap level. Surface trap parameters, surface conductivity, surface charge density, and surface flashover voltage were calculated and measured. It indicates that surface flashover voltage improves by 23.07% and 14.45% compared to pristine EP when solely introducing MWCNTs or nano-TiO2 particles into the EP matrix, while it increases by 36.04% for C0.1T2 as simultaneously introducing both particles. When adding small amounts of particles, the surface charge transport is suppressed due to the introduction of bonded layers in the interfacial region, and the surface deep trap level is improved. As the surface deep trap level increases, charge transport and electron emission processes in the solid surface layer are hindered, which reduces the surface positive charge density and the distortion of the electric field and further results in the reduction of surface conductivity and the improvement of dc surface flashover voltage in a vacuum. The explanation for the effects of surface deep traps on surface flashover is essential for further improvements of surface flashover.