Cardinal and Ordinal Directions Approach in Investigating Arrayed Solder Joints Crack Propagation of Ball Grid Array Semiconductor Packages

An accelerated reliability testing via thermal cycling test (TCT) was used to test ball grid array (BGA) components’ reliability. Five variables were observed; control sample J and samples K, L, M, and N were BGA component samples that have been exposed to TCT between 500 and 1250 cycles with the TCT profile in the range of 0 °C–100 °C. The crack orientation of the individual solder joint was analyzed along with the propagation path pattern on the solder array of the BGA component pad by analyzing the dye and pull test results that were then mapped and analyzed using the cardinal and ordinal directions approach. This is to determine the crack propagation path direction in the solder array and track the potential of warpage on the BGA package as the TCT cycles progressed. A cross section was performed on sample M with the 3-D X-ray and scanning electron microscopy (SEM) analysis to observe the solder joints’ fracture lines and surface topographies. The results showed that individual solder joint crack orientation is correlated to the crack propagation location on the BGA package. The solder joint from northwest (NW), northeast (NE), southeast (SE), and southwest (SW) of the BGA package is prone to solder crack compared to the solder joint array in the middle. A solder grain structure coarsening occurred at the crack propagation due to the high cyclic strain from the TCT.