On the Trade-Off Between Enhancement of the Spatial Resolution and Noise Amplification in Conical-Scanning Microwave Radiometers

The ability to enhance the spatial resolution of measurements collected by a conical-scanning microwave radiometer (MWR) is discussed in terms of noise amplification and improvement of the spatial resolution. Simulated (and actual) brightness temperature profiles are analyzed at variance of different intrinsic spatial resolutions and adjacent beams overlapping modeling a simplified 1-D measurement configuration (MC). The actual measurements refer to Special Sensor Microwave Imager (SSM/I) data collected using the 19.35 and the 37.00 GHz channels that match the simulated configurations. The reconstruction of the brightness profile at enhanced spatial resolution is performed using an iterative gradient method which allows a fine tuning of the level of regularization. Objective metrics are introduced to quantify the enhancement of the spatial resolution and noise amplification. Numerical experiments, performed using the simplified 1-D MC, show that the regularized deconvolution results in negligible advantages when dealing with low-overlapping/fine-spatial-resolution configurations. Regularization is a mandatory step when addressing the high-overlapping/low-spatial-resolution case and the spatial resolution can be enhanced up to 2.34 with a noise amplification equal to 1.56. A more stringent requirement on the noise amplification (up to 0.6) results in an improvement of the spatial resolution up to 1.64.