Simulation and Measurement of Locomotive Antennas in the Installed State Based on a Scaled Mockup

Accurate characterization of locomotive antennas is key to safe and robust railway signaling and control communication. With the introduction of new technologies and the foreseeable migration from the GSM-R standard towards FRM CS, new wireless applications and specifications arise, and suitable antenna solutions need to be developed and tested. Moreover, the rooftops of modern locomotives present a dense and harsh environment; therefore, potential antenna mounting spaces should be carefully evaluated to avoid undesirable degradations of the antenna radiation patterns. Due to the electrically large and complex structure of locomotives, full-scale testing is challenging to perform, especially under laboratory conditions. Antenna measurements with geometrically scaled models present a powerful alternative to address this issue. In this paper, we present and discuss antenna measurement results of a scaled locomotive mockup. The mockup incorporates two different cabin geometries, one with a step-like rooftop contour, and one with a smooth slightly tilted geometry. First, the optimum scaling factor was identified and validated through numerical simulations. Afterwards, antenna measurements with a scaled locomotive mockup were carried out in our automotive antenna measurement facility VISTA. The measured results were compared with the numerical simulations, where a good correlation above 80 % was found. Secondly, the impact of the rooftop geometries, and superstructures on the roof has been investigated for a range of operational frequencies between 700 and 2600 MHz. The results reveal that the parasitic impact of the antenna environment becomes more pronounced at higher frequencies.