DBD-microdischarges in an asymmetric geometry with rotating barrier electrode: First experimental attempts and benchmarking studies

The nature and physical parameters of dielectric barrier discharges (DBDs) are determined by the presence of dielectric material in the discharge gap. The charging of the dielectric barrier is responsible for the non-thermal regime as it limits the local energy dissipation. In an operating DBD residual surface charges can influence the distribution and development of the plasma in the following discharge cycles
¹
. In order to learn more about residual surface charge role an experiment with a rotating dielectric electrode and a pin electrode (325 μm tip radius) is realized
²
. The rotating dielectric barrier enables DBD-operation with DC high voltage and, the remaining surface charges are removed by a second grounded electrode which is sliding over the dielectric. Thus, single, repetitive microdischarges in air at atmospheric pressure are ignited without participation of residual surface charges. These microdischarges were investigated by ICCD camera, electrical measurements and time-correlated single photon counting (sub-ns, sub-mm and spectral resolution). For positive polarity of the pin electrode a positive streamer starting from the middle of the gap followed by a secondary wave starting from the metal electrode is observed. For negative polarity an anode directed wave of light and a weaker glow in front of the cathode are obtained.