Experimental Study On the Critical Current of CORC Cable Under Cyclic Bending-straightening

To develop the application potential of conductor on round core (CORC) cables in the next generation of fusion magnets and accelerator magnets, fully automatic mechanized winding technology is required for the long CORC cables manufacturing. Meanwhile, the manufacturing and usage of the CORC cable are both limited by the strain sensitivity of the wound ReBCO tape on the CORC cable, because the processes may cause the superconducting layer of the ReBCO tape damaged when the strain limit is exceeded. The strains can arise from the manufacturing, bending, cooling, and operation of the cable and magnet, especially for the needed cyclic bending-straightening procedure for a long and multilayer cable winding layer by layer. Thus in this manuscript, a 1-m-long 12-layer CORC cable was manufactured to study the influence of cyclic bending on the critical current carrying performance of the CORC cable. It is consisted of 28 ReBCO tapes from Fujikura with 4 mm width and 0.05mm substrate thickness. The central core has an outer diameter of 3.85 mm. The cyclic bending-straightening experiment was conducted with a bending diameter of 900 mm and 700 mm, the Ic was tested at 77 K and self-field. After the cyclic bending test, the sample was bended to a diameter of 95 mm, which is planned to be used for the following insert solenoid coil, and has been verified no influence on the critical current carrying performance if bended without cyclic bending-straightening treatment. The results show that the required diameter for the reel experiencing cyclic bending-straightening procedure for ReBCO cable winding is suggested to be larger than 700 mm, especially for the equipment used for multilayer cables winding.