A Compact Active Ka-Band Filtenna for CubeSats

This letter describes the design of a right-hand circularly polarized planar filtenna (filter + antenna) that can reconfigure its operation between two center frequencies in the Ka-band. The filtenna structure is composed of a four-element array radiator and a reconfigurable bandpass filter, occupying an area of 31 × 14 mm. The circularly polarized array elements are fed by a sequential power divider for an enhanced polarization purity. The filter is based on a ring resonator loaded with a variable open stub. The length of the stub extends through a p-i-n diode switch, resulting in a change of the loaded reactance into the ring, and consequently tuning the filter's operating center frequency from 30.3 to 29 GHz. The proposed low-loss filtenna structure exhibits a reconfigurable fractional bandwidth up to 7.74%, a peak realized gain that can reach up to 11.5 dBic, an axial ratio of less than 1 dB, and a sidelobe level that can go as low as −12 dB. The prototype filtenna is fabricated and tested, where the measured results verify the simulated data. A figure of merit is proposed to highlight the superior performance of the presented Ka-band structure in terms of the polarization, size, reconfiguration ability, and radiation characteristics as proven by the comparison with other works in the literature.