Iterative multiuser detection for turbo-coded FHMA communications

An iterative receiver structure Is proposed for turbo-coded frequency-hop multiple access (FHMA) systems. In FHMA systems, the adjacent channel interference (ACI) is the major contributor of multiple access interference (MAI) if orthogonal hopping patterns are used. The ACI is a function of the tone spacings of the adjacent subchannels and the rolloff factor of the pulse-shaping filter. The calculation of the ACI for a square-root raised-cosine pulse-shaping filter in an FHMA system is presented in this paper. In addition, a low complexity iterative multiuser detector is developed to mitigate the degradation caused by ACI in the FHMA systems. The iterative receiver structure is based on a modified turbo decoding algorithm which makes use of the a posteriori log-likelihood ratio (LLR) information of the systematic bits to obtain the a posteriori information of the turbo-encoded parity bits. Iterations of the receiver/decoder are used as the mechanism to estimate and mitigate the MAI in the FHMA system. The properties of both soft and hard interference suppressors based on the modified turbo decoding algorithm are examined and an efficient recursive implementation is derived. Compared to maximum-likelihood multiuser detection, the proposed system is more practical and its complexity is only a linear function of the number of users. Simulation results show that the proposed iterative receiver structure offers significant performance gain in bandwidth efficiency and the required signal-to-noise ratio (SNR) for a target bit-error rate (BER) over the noniterative receiver structure. Moreover, the single user performance can be achieved when imperfect power control exists.