Analysis of Measurement Accuracy of Multi-Objective Normalization Algorithm Under Different Reference Systems

Aiming at the problem that the base coordinate system of industrial robot is not unified with the center coordinate system of tool, and it is impossible to input the action position in the robot teaching device, this paper adopts ROMER HEXAGON METROLOGY 7530SE three-coordinate measuring instrument as the robot measuring equipment and proposes a multi-objective normalization algorithm. In this paper, the reliability of the multi-objective normalization algorithm is verified by the experiment, and the measurement accuracy difference of the multi-objective normalization algorithm under different reference systems is studied. The results have shown that the accuracy of the system reaches 0.8 mm and the root mean square (RMS) value is maintained at 0.3-0.7 mm when the engine is taken as the reference coordinate system within the robot's 0-50mm motion stroke. When the body-in-white is used as the reference coordinate system, the accuracy of the system can reach 2.2 mm, the RMS value can be maintained at 1.0-1.8mm. The reasons for good accuracy and stability of the measurement system established with the engine as the reference coordinate are analyzed. The multi-objective normalization algorithm proposed in this paper has high engineering universality, and the accuracy analysis of the algorithm under different reference system has guiding significance for the selection of reference coordinate system of measurement system.