An Evaluation of the CAN bus for Use on the Europa Lander Motor Controller

This paper will present the application of the Controller Area Network (CAN) for communication between the Motor Control Processor and the Europa Lander Motor Control Cards. The Europa Lander preproject team is concerned about lowering the estimated mass, volume, and power of the mission concept so that it could maximize its science return. The motor controller uses multiple Motor Control Cards to control the 24 motors that will be operating in the extremes of the Europa environment. The CAN bus was considered because of its multi-drop nature, low power interface, and simple communication protocol. Beyond communication with the motor controller cards we also use the CAN bus interface to gather telemetry from the Power Conversion Card. Our system requires the collection of telemetry at a rate of 64Hz from the Power Conversion Card and all active motor controllers along with the sending of control packets and the receipt of control parameters at 512 Hz. In the paper we will address the ability of the CAN bus to meet these requirements along with our Arduino based test system used to learn about the CAN bus standard and verify our analysis.