Modulation Strategies for Anisotropy-Based Position Estimation of PMSMs Using the Neutral Point Voltage

Information obtained about magnetic anisotropy via neutral point voltage measurements can be used to estimate the position of synchronous and induction machines at all speeds including standstill. Due to its usually high signal-to-noise ratio, this estimation method can be an attractive alternative to approaches that acquire anisotropy information via current measurements. The position estimation method looked at in this paper relies on anisotropy information in the form of position-dependent inductance ratios. These are obtained through measurement of the voltage between the machine’s neutral point and an artificial neutral point during the application of different voltage vectors via a two-level switching inverter. We analyze the conditions placed on and the consequences of implementing necessary modifications to a standard space vector modulation. Five different modified modulation strategies are compared and investigated, including two newly proposed strategies which use only a minimal set of active and zero voltage vectors for measurement of the inductance ratios and therefore allow high utilization of available voltage and a high update rate of the estimated position. Experimental results for three low-power three-phase permanent magnet synchronous machines are presented which suggest that modulation strategies that use active measurement vectors in all three instead of only two axes of the machine are less susceptible to systematic deviations in the position estimation that presumably result from nonlinear machine properties. As part of the machine model, a normalizing inductance variation ratio is introduced, which simplifies expressions and supports the comparison of motors.