Comparison of Microinverters: Update on conversion efficiencies and energy yields

To compare efficiency and yield of many micro-inverters available on the world market in 2014-2020, an in- and outdoor test laboratory at the University of Paderborn has been set up. The inverters have been fed by identical and calibrated crystalline silicon PV modules of 215 W
_p
. To monitor accurately DC input, AC power output and energy yield, each of the micro-inverters has been equipped with a calibrated electricity meter. For micro-inverters requiring control units for grid-feeding that has been acquired also. The comparison covers efficiency-load characteristics as well as electrical energy yields. Purchase costs vary considerably between the models in comparison, sometimes inverter costs are higher than module costs, particularly if an additional grid-connection or interface device is needed for operation. The weighted conversion efficiency according to EU and CEC standards has been measured and calculated. While some inverters have been optimized for high irradiance levels, they ranked better at the CEC efficiency, others performed very well also for low irradiance levels, thus ranking higher at in the EU-efficiency tables. These results are deviating from the actual energy yield measurements, which show a slightly different ranking. At one inverter, an accurate, but very slow MPPT algorithm that barely could follow quickly changing irradiance levels could be the reason for this effect. Another inverter switched off after operation at high power output for a while. Apparently, some inverters are been optimized to show excellent EU and CEC efficiency ratings. Two of the inverters featuring two inputs did not show an exceptional performance at the EU- and CEC-ratings, but they achieved top ranks at the AC energy yield for the first years. For the customer, the AC yield is a major performance indicator of any microinverter and should be included in the datasheet.