Corrections to “3D Printed Elastomeric Lattices With Embedded Deformation Sensing”

In the above article
[1]
, Figure 3 should read “Isometric view of two wires forming a capacitor in the measured configuration. The yellow wire is the top plate and the red is the bottom plate of a capacitor. The gray is a dielectric elastomer lattice, the deformation of which can be indirectly determined by measuring the capacitance.” Figure 4 should read “Isometric (A) and bottom view (B) of a lattice with an alternative configuration in four quadrants for selective sensing. The selectivity can be extended to any combination of cells in both vertical and horizontal configurations.” In
Figure 9
, the
${x}$
-axis should read “Min Deformation Slow; Min Deformation Fast; Max Deformation Slow; Max Deformation Fast.” A sentence in the introduction should read “Within the context of additive manufacturing, lattices are the focus of significant research since they...” The authors requested this correction for clarity purposes.