Adaptive Distance Relaying for Distribution Lines Connecting Inverter-Interfaced Solar PV Plant

Distribution lines are generally protected by overcurrent relays. With the integration of an inverter-interfaced solar photovoltaic (PV) plant having a current-limiting feature, the fault current seen by the relay on the PV side of that feeder becomes comparable to the load current. The conventional overcurrent relaying principle is not suitable for distribution line protection. Distance relay may be a viable option for protection of distribution lines connecting the solar PV plant. However, positive- and negative-sequence source impedances of the PV plant depend on an inverter controller, which results in limited performance of fixed setting distance relay. This article proposes an adaptive distance relay setting to protect distribution line connecting the PV plant, using prefault voltage and current data at the relaying point. The method calculates positive- and negative-sequence PV source impedances for boundary setting of distance relay at the PV side. The proposed trip boundary is modified adaptively with the change in prefault conditions of the PV plant. Performance of the proposed method is tested for different control strategies and operating capacities of the PV plant and variation in the grid source impedance on a 34-bus distribution system. Real-time application of the proposed method is validated in hardware-in-the-loop using OPAL-RT simulators with IEC 61850 as the communication protocol and found to be accurate.