Using a Motion Capture System as Reference for Motion Tracking in Photoplethysmography Imaging

Photoplethysmography Imaging (PPGI) is a camera-based and non-contact technology for measurement of physiological signals. It has been shown that important physiological parameters such as heart rate, heart rate variability and respiratory rate can be derived from PPGI. However, as is the case with most non-contact measurement techniques, motion artefacts present a major challenge. Various algorithms for application to both the 2D PPGI video frames as well as the resulting 1D PPGI waveforms have been developed in order to enhance robustness against motion. In this paper, we focus on the aspect of feature point tracking in the 2D PPGI video sequences. We present an experimental setup, where we used a motion capture system in order to obtain a reference for motion during the recording of PPGI video sequences. In a laboratory experiment, PPGI video sequences were recorded from ten healthy volunteers, who were asked to perform various movements during the recording. The KLT tracking algorithm was applied to the recorded sequences and results compared with the reference values from the motion capture system. The results indicate, that tracking of measurement regions in PPGI video sequences is only one element towards motion robust PPGI. In most scenarios, tracking is not sufficiently precise, requiring further processing of the PPGI waveforms in order to reduce motion artefacts in PPGI signals. These indications were confirmed by further analysis when we looked into the effects of tracking on PPGI heart rate extraction.