Light Output Evaluation of Plastic Scintillator Fabricated by DLP 3D Printer

3D printing technique of Digital Light Processing (DLP) was applied to the fabrication of plastic scintillator. Photoinitiator was used with scintillating components to apply this 3D printing technique using UV-polymerization. The fabricated plastic scintillator was evaluated by large area avalanche photodiode (LAAPD) and
¹³⁷
Cs radiation source, and compared to commercial plastic scintillator BC408 (Saint-Gobain Crystal). The number of electron-hole pair per 1 MeV-γ for the plastic scintillators was measured using LAAPD. The detector was calibrated for
⁵⁵
Fe X-ray source. The number of photons per 1 MeV-γ was calculated by applying effective quantum efficiency of the LAAPD and the reflectivity of Teflon tape to the number of electron-hole pairs. As a result, light output 6,450 ph/MeV of the fabricated plastic scintillator was measured, which was 87% relative performance to BC408.