Digital Amplifier: A Power-Efficient and Process-Scaling Amplifier for Switched Capacitor Circuits

To realize high-resolution pipelined and pipelinedSAR analog-to-digital-converters (ADCs), an accurate residue amplifier is necessary. However, realizing such an amplifier in scaled CMOS is challenging due to the worsened transistor characteristics. Prior works focused on gain calibration techniques to mitigate the use of low-gain amplifiers, in return of system complexity and prolonged startups. In this paper, we introduce a digital amplifier (DA) technique to realize powerefficient and accurate amplification in scaled CMOS. DA cancels out all errors (i.e., gain error, nonlinearity, incomplete settling, power supply noise, and thermal noise) of the low-gain amplifier by feedback based on successive approximation. The DA accuracy can be arbitrary set by configuring the number of bits in the DA capacitor digital-to-analog-converter; the amplifier gain is decoupled from the transistor intrinsic gain which is suitable for scaled CMOS integration. We also show that the power efficiency can be enhanced over conventional opamp-based designs with relaxed settling error requirements of DA-based multiplying digitalto-analog-converters (MDACs). Moreover, the circuit design of DA-based MDACs is further discussed. Measurement results of the calibration-free 0.7-V 12-bit 160-MS/s pipelined-SAR ADC implemented in 28-nm CMOS are reported. Without calibration, the ADC achieves signal-to-noise-and-distortion-ratio = 61.1 dB, figure-of-merit = 12.8 fJ/conv., which is over 3× improvement compared with conventional calibration-free high-speed pipelined ADCs. In addition, we evaluate the DA's process scalability by comparing the measured results of the DA-based MDAC prototyped in 65and 28-nm CMOS. We observe 2×-3× improvement in speed, power, and area mainly resulting from the DA's process scalability.