Modelling an Efficient Gap Filler for DTT Network Using ADS Software

This paper proposes the modelling and simulation of a special gap filler intended to cover grey areas in the DTT network of Accra. This has become necessary due to the numerous areas of low signal coverage in the Accra DTT and the incapability of previous methods to efficiently address the problem. The ADS simulation consists of arrangements of components from the DBV-T library which consists of filters, amplifiers and a power source. This setup mimics a gap filler system with a better noise reduction implementation, several frequency values are being used for the simulation process. A significant increase in the output signal as in comparison to the input means the shaded areas will be properly covered. The results derived from the simulation of the ADS setup highly improved upon the output signal values, when compared to the ITU standard. Three (3) out of five (5) simulation results show values beyond the minimum signal level requirement. Also using MATLAB, the RF propagation toolbox which has the map tool feature was able to implement the gap fillers into the Accra area and gave a visual representation of the signal strength. Modelling a gap filler system which has better noise cancellation and which propagates better with a dipole antenna was achieved in this paper. The outcome of the paper shows that the gap filler modelling increase signals in grey areas.