Increase of Rolling Mill Electric Drive Precision

The principles of increasing the precision characteristics of an electric drive are presented in this article. There are achieved by analyzing the requirements for the electric drive by the operating body. The scientific work has a relationship between the parameters of the quality of rolling the pipe and the precision parameters of the electric drive in terms of overshoot parameters and absolute positioning accuracy. It is shown that this dependence is non-linear in the position electric drive and depends more on the size of the overshoot and a significantly smaller ratio from absolute accuracy. The permissible overshoot value depends on the absolute accuracy and has range from 5 to 10%. The largest value of the overshoot is achieved with absolute positioning accuracy with an error not exceeding 2%. The obtained values of the control parameters can be successfully applied in the design of the position electric drive. So, if you provide sufficient positioning accuracy with an error not exceeding 2%, which is achieved by the use of position sensors with a resolution of at least 10 000 pulses per revolution, the modeling electric drive in the position loop can be adjusted with an allowable overshoot of 10%, and therefore, increased system performance while maintaining quality control indicators.