Compressed Sensing Method for IGBT High-Speed Switching Time On-Line Monitoring

Condition monitoring (CM) has been considered as a promising technique to improve the reliability of insulated gate bipolar transistors (IGBTs). Among various condition parameters, switching time is a good health status indicator to detect IGBT failures. However, on-line monitoring of the IGBT high-speed switching time is still difficult in practice due to the requirement of the extremely high sampling rate for signal acquisition. To overcome the technical difficulty, this paper provides an innovative compressed sensing (CS) method to achieve equivalent sampling performance for high-speed IGBT switching time monitoring with a lower sampling rate. By utilizing the sparse characteristics of an IGBT switching signal, the sampling rate in the CS method could be far less than the traditional Nyquist sampling rate. To clarify the method, the CM mechanism using IGBT switching time is first analyzed. Then, three key points in the CS method are studied, i.e., the selection of sparsifying basis, the design of a measurement matrix, and the implementation of a reconstruction algorithm. Finally, experiments are carried out to investigate the performance of the CS method for on-line CM. Experimental results show that the IGBT turn-off time at different temperatures can be accurately monitored with a highly compressed sampling rate, which validates the feasibility and effectiveness of the proposed method.