A 450 fs 65-nm CMOS Millimeter-Wave Time-to-Digital Converter Using Statistical Element Selection for All-Digital PLLs

This paper presents a time-to-digital converter (TDC) that operates with a 20-64 GHz input and underpins the phase digitization function in a millimeter-wave all-digital fractional-N frequency synthesizer. A self-calibrated inductor-less frequency divider using dynamic CML latches provides an eightphase input to a 3-bit “coarse” TDC, which is interfaced to a 5-bit “fine” TDC through a sub-sampling coarse-fine interface circuit. A wide bandwidth low dropout (LDO) on-chip regulator is used to decrease the effect of supply noise on TDC performance. A synthesized digital engine implements calibration using statistical element selection with mean adaptation to alleviate TDC nonlinearity that results from random mismatches and PVT variations. The TDC is fabricated in 65-nm CMOS along with the divider and calibration circuits, and achieves 450-fs resolution. The measured DNL and INL of the TDC are 0.65 and 1.2 LSB, respectively. The TDC consumes 11 mA from 1-V supply voltage. The TDC features a figure-of-merit of 0.167 (0.47) pJ per conversion step without (with) the frequency divider. A single-shot experiment shows that the on-chip LDO reduces the effect of TDC noise by reducing the standard deviation from 0.856 to 0.167 LSB for constant input. The prototype occupies an active area of 502 × 110 μm
²
excluding pads.