Construction and Testing of Curved ReBCO Coils

In many applications dipole magnets with coils having significant curvature are needed. This is particularly challenging for high temperature superconductors (HTSs) as they are brittle. One possible application for curved HTS coils was the fragment separator dipole magnets for the Facility for Rare Isotope Beams (FRIB). For this application these magnets would operate in a high radiation environment and would be subject to a high heat load. Removal of heat generated in magnets in this environment using conventional Ni–Ti and Nb
₃
Sn superconductors, which generally operate at ∼4.5 K, is difficult. However, an HTS conductor can be used to permit operation at 40 K where heat removal is significantly more efficient. As these coils are curved, one side of the coils has a reverse curvature requiring the development of special technology to wind the coils. As part of an STTR grant to develop and demonstrate a super-ferric design for a 2.2 T magnet, two curved coils were fabricated with a 12-mm-wide SuperPower ReBCO conductor and first tested in liquid N
₂
at 77 K. Afterwards the coils were installed into a cryostat and cooled to the design temperature of
48
K with cryocoolers. This paper presents the construction details and test results for these coils.