Adaptive RF Front-Ends Using Electrical-Balance Duplexers and Tuned SAW Resonators

This paper proposes an adaptive RF front-end (RFFE) architecture that uses an electrical-balance duplexer (EBD) and tuned surface acoustic wave (SAW) resonators to enable adaptive dual-frequency isolation suited for LTE's frequency-division duplex (FDD) mode of operation. Alternatively, in the in-band full-duplex (IBFD) mode, the EBD cancels the in-band TX self-interference directly at RF for increased channel capacity. Furthermore, the EBD's balance network is optimized to reduce the TX insertion loss (IL) below the nominal 3-dB limit in the FDD mode. A 0.18-μm SOI CMOS prototype implements the EBD, low-noise amplifier, and SAW-tuning capacitor banks. The chip is mounted to a module substrate together with the SAWs and matching components. The RFFE achieves >50-dB dual-frequency isolation and 2.6-3.4-dB TX IL in FDD mode, has +58/+42-dBm TX/RX-path IIP
₃
for an increased IBFD-link budget and handles up to +27.5-dBm TX power in both modes.