Control Method for the Sheppard–Taylor PFC Rectifier to Reduce Capacitance Requirements

Sheppard-Taylor power factor correction (ST-PFC) rectifier could obtain a high power factor due to its capability of overcoming the control detuning issue. However, it needs a bulky electrolytic capacitor at the load side to buffer the double-frequency ripple power (DFRP), which reduces the reliability and power density significantly. This paper proposes a control method to divert the DFRP to the small energy transfer capacitor. Consequently, the bulky electrolytic capacitor is replaced with a small film capacitor. The proposed method is carried out by introducing the freewheel state (one switch is turned on and the other is turned off) into the control. So no extra hardware is added, which makes the proposed method cost-effective. A low electromagnetic interference emission is also achieved due to the continuous input-output currents. In addition, the proposed method can be extended to other topologies easily. This paper first gives the detailed analysis of the proposed control method, and then introduces the controller design. The selection of the passive components is also briefly discussed. Finally, the simulation and experimental results verify the effectiveness of the proposed control method.