Cabling Technology of $\hbox{Nb}_{3}\hbox{Sn}$ Conductor for ITER Central Solenoid

Under the International Thermonuclear Experimental Reactor (ITER) project, the Japan Atomic Energy Agency (JAEA) is procuring all of the Nb
₃
Sn conductors for the Central Solenoid (CS). The CS consists of six vertically stacked modules. The height and outer diameter of the CS are approximately 13 m and 4 m, respectively. The CS has a circular five stage cable. All of approximately 43 km of Nb
₃
Sn CS cables will be manufactured in Japan. Before mass-production start, the jacketed cable conductors should be tested in the SULTAN facility in Switzerland to confirm their superconducting performance. The original cabling design had relatively long twist pitches and is referred to as the normal twist pitch (NTP) conductor. The NTP conductor test results revealed decreasing the current sharing temperature (Tcs) with increasing number of electro-magnetic (EM) load cycles. Therefore, a short twist pitch (STP) design was proposed and the STP conductors were also tested. The STP conductor results showed that the Tcs is stable during EM cyclic load tests. Because the conductors with STP have a smaller void fraction in the cable area than those with NTP, a higher compaction ratio during cabling is required and the possibility of damage on strands increases. The STP cable technology was developed in collaboration among Japanese cabling suppliers and JAEA. Several key technologies will be described in this paper.