MIR measurements of atmospheric water vapor profiles

Three subjects related to atmospheric water vapor profiling using the 183.3 GHz absorption line are discussed. First, data acquired by an airborne millimeter-wave imaging radiometer (MIR) over ocean surface in the western Pacific are used to estimate three-dimensional (3D) distribution of atmospheric water vapor. The instrument's radiometric measurements with mixed vertical and horizontal polarizations require modifications to the retrieval algorithm used in the past. It is demonstrated that, after the modifications, the new algorithm can provide adequate retrieval of water vapor profiles, even though the measured data are of mixed polarizations. Next, the retrieved profiles, in terms of water vapor mixing ratio /spl rho/ (g/kg), are compared with those measured in near concurrence by dropsondes from a research aircraft in the western Pacific and by a ground-based Raman lidar at Wallops Island, Virginia. The ratio of the standard deviation to the mean /spl rho/ is found to be 0.12 at 0.25 km altitude and gradually degraded to 0.67 at the highest altitude of the retrieval of 10.25 km. Finally, the effect of the "initial guess" relative humidity profile on the final retrieved product is analyzed with respect to the condition for the convergent retrieval. It is found that the effect is minimal if the initial profile is not unrealistically different from the true one. If the initial profile is very different from the true one, the final retrieved product could be subject to a substantial error. Tightening of the convergent condition in the retrieval helped reduce magnitude of the error, but not remove it totally. It is concluded that an initial profile based on climatology is likely to provide most reliable retrieval results.