NO2 QCM gas sensor based on electrochemical deposition of PEDOT

In this paper the authors describe the development and the characterization of a Quartz Crystal Microbalance (QCM) sensor for NO2 detection with the sensitive layer made of a thin films of poly (3,4-ethylenedioxythiophene) (PEDOT). The PEDOT layer was obtained by electropolymerization on one of the gold electrodes of a 10 MHz AT-cut commercial quartz crystal. The sensor performance in terms of sensitivity and selectivity were assessed exploiting an ad hoc chemical sampling unit, and a low noise conditioning and processing electronic system. This latter consists of an oscillator hosting the piezoelectric resonator, and of a frequency measurement system granting a (short time) relative accuracy of approximately 10
⁻⁸
, which ensures a mass resolution in the order of the ng. The preliminary obtained results show a NO
2
resolution and sensitivity of the order of 1 ppm, and 2.6 Hz/ppm, respectively, at 35 °C constant room temperature and in a dry environment, and show that a satisfactory repeatability can be achieved with recovery cycles in N
2
at room temperature.