Synchronisation in safety-critical distributed control systems

Distributed computer systems for real-time control require a global timebase with high precision. A small time skew between local clocks in the system is required to obtain good control performance through well synchronised task execution, but also provides a base for efficient communication. In distributed safety critical applications, clocks have traditionally been synchronised with fault tolerant clock synchronisation algorithms. With these methods, a limited number of erroneous clock readings are allowed in each adjustment. On the other hand, readings from all clocks in the system are required before an adjustment can be made. In this paper an alternative approach, the Daisy Chain method, is proposed and compared with present solutions. Daisy Chain synchronisation does not allow erroneous clock readings, but methods of avoiding them are described. Due to its simplicity, the method can be implemented with little hardware. Low precision frequency sources are sufficient and recovery after arbitrary failures is fast because no special start up phase is required. The paper also discusses effects of quantisation uncertainty and transmission delay, and outline the implementation of a global time base in an embedded distributed real-time architecture.<
>