A simple scheme for unity power-factor rectification for high frequency AC buses

A simple scheme is proposed for offline unity power factor rectification for high-frequency AC buses (20 kHz). A bandpass filter of the series-resonant type, centered at the line frequency, is inserted between the line and the full-wave rectified load. The Q=Z/sub 0//R/sub L/ formed by the load and the characteristic impedance of the tank circuit determines the power factor, the boundary between continuous and discontinuous conduction modes, the peak stresses, and the transient response of the rectifier. It is shown that for Q>2/ pi the rectifier operates in continuous conduction mode and the output voltage is independent of the load. Also, it is shown that for Q>2 the line current is nearly sinusoidal with less than 5% third-harmonic distortion and the power factor is essentially unity. An increase in Q causes an increase in the peak voltages of the tank circuit and a slower transient response of the rectifier circuit. The DC, small-signal, and transient analyses of the rectifier circuit are carried out, and the results are in good agreement with simulation and experimental results.<>