On the two modes of operation of monolithic Ag-C brushes

The previously observed transition from low-temperature (mode I) to high-temperature (mode II) behavior in silver-graphite brushes can be explained either by changes of constriction resistance through the temperature dependence of electrical resistivity and hardness at negligible film resistivity and one to three contact spots, or by loss of graphite lubrication within the interfacial film. These two interpretations were tested by controlling the contact spot temperature: (1) by heating in an oven and (2) by local heat input through friction. Correlated studies of contact resistance, friction, wear rate, wear chip size, wear chip microstructure, and calculations of contact spot temperatures favor the second hypothesis. Micrographic evidence suggests that this occurs through desorption of water vapor from the graphite. It is found that primary wear particles form due to the wedge mechanism and by cutting by graphite fragments steeply inclined to the interface. Silver fragments may consolidate into secondary wear particles.<
>