Nanometer Scale Actuation Of Magnetic Head Elements in Hard Disk Drives with Built-In Microheater

Today's head/disk interface design has a wide flying height distribution due to manufacturing tolerances, environmental variations, and write-induced thermal protrusion. To reduce the magnetic spacing loss caused by these effects, we developed an active head slider with a nano-thermal actuator. The magnetic spacing of these sliders can be controlled in-situ during drive operations. After simulating the heat transfer in the slider to obtain the thermal deformation of the air-bearing surface, we fabricated a thermal actuator using thin-film processing. An evaluation done using a read/write tester showed a linear reduction in the magnetic height as electric power was applied to the actuator. The actuator's stroke was 2.5 nm per 50 mW with a time constant of 1 msec.