Circularly symmetric RF commutator for cylindrical phased arrays

A new feed concept is described which greatly simplifies the problem of commutating the RF distribution system of a cylindrical phased array. The feed consists of a circular parallel-plate radial transmission line with a central set of probes and a ring of peripheral probes. The array of probes in the center can be phased to produce an amplitude distribution in the parallel-plate line in any given direction. Proper setting of only two phase shifters connected to the central probes can cause any sector of the peripheral probes to be excited with the proper amplitude distribution necessary to produce a directive pattern with low sidelobes as well as a monopulse difference pattern when the peripheral probes are connected, through collimating phase shifters, to the active radiating elements of a cylindrical array. The cylindrical array can be scanned through360\degin fine increments by continued indexing of the amplitude distribution generated by the central probes. ExperimentalLband hardware, built to prove the feed technique, is described. Nine central probes in a 0.25-inch thick 21-in diameter model produced a cardioid distribution and an orthogonal figure-eight distribution which could be commutated together by adjustment of two phase shifters. Measured insertion loss between the central probes and 48 peripheral probes showed only 0.1-dB loss over a 6-percent band. Coupling measurements between the three available central terminals indicated isolation between the various ports of 23-35 dB. The minimum insertion loss and the corresponding transmission phase between the central feed and the peripheral probes was shown to be independent of the setting of the two control phase shifters which were set to have conjugate phase shift.