On the Use of Tomographically Derived Reflectivity Profiles for Pol-InSAR Forest Height Inversion in the Context of the BIOMASS Mission

Model-based forest height inversion from single-and multi-baseline Pol-InSAR data is today well-established. One of the critical performance points is the parameterisation of the vertical reflectivity profile. In this paper, the parameterisation of the vertical reflectivity profile using a tomographic reconstruction is proposed. To mitigate the limitations in the tomographic reconstruction induced by the limited vertical resolution especially for the ground scattering component, the ground and volume contributions are separated using the Sum of Kronecker Products (SKP) decomposition. For the forest height inversion, the Pol-InSAR line inclination angle is proposed, which, unlike the absolute coherence and the phase center, is invariant to the presence of a residual Dirac-like ground scattering contribution. The inversion performance is addressed and compared for both single- and multi-baseline cases, in the absence and presence of temporal decorrelation. In all cases the ground elevation is estimated from the tomographically reconstructed vertical reflectivity profiles and its accuracy directly influences the achieved inversion performance. The proposed methodology establishes a link between interferometric and tomographic measurements and is therefore relevant for missions that allow the implementation of both techniques. ESA’s BIOMASS is one such mission, and as such is being used as a test case to discuss different implementation scenarios. The different inversion strategies are applied on P-band campaign data acquired in the frame of the AFRISAR 2016 experiment and validated against reference measurements.