Distributed Bragg-reflector Pb1-xSnxTe/PbSeyTe1-ydiode lasers

Distributed Bragg-reflector (DBR) diode lasers were designed and fabricated from lattice-matched Pb
1-x
Sn
x
Te/PbSe
y
Te
1-y
single heterostructures grown by liquid-phase epitaxy. These DBR lasers operated in a single longitudinal mode within a limited range of heat-sink temperatures, 8.5-38 K, with a threshold current density of ∼3 kA/cm
²
at 20 K. Single longitudinal mode operation was maintained up to more than three times the threshold current. Continuous tuning of the laser output frequency over a range of ∼6 cm
^-1
, near 775 cm
^-1
(12.9 μm), was acheived by varying the heat-sink temperature. The average tuning rate was 0.21 cm
^-1
/K, and it was much smaller than the rate for corresponding Fabry-Perot lasers, which was 2.3 cm
^-1
/K. The measured effective mode index of the DBR lasers agrees well with the calculated one.