Influence of 16 kHz-30 kHz Sinusoidal Voltage on Surface Discharge Characteristics at Different Pressures

Due to the specific communication requirements of high-altitude platforms like research institutes and monitoring stations in mountainous areas, as well as aircraft, voltage sources operating within very low frequency (VLF) range (specifically between 16 kHz and 30 kHz) are frequently utilized. High-frequency and high-voltage conditions increase the risk of surface discharge, posing a significant threat to the normal operation of high-voltage equipment. Existing insulation designs often refer to power frequency test results under low-pressure conditions, which often lead to insulation failures. Previous research has primarily focused on the effects of power frequency or voltage below 2 kHz on insulation characteristics at atmospheric pressure. In this work, we have built an insulation test platform to conduct surface discharge experiments at both power frequency and VLF. The pressure range is 20 kPa-60 kPa. The surface discharge inception voltage (SDIV) and breakdown voltage(BDV) of epoxy resin and PTFE boards are investigated under highly non-uniform fields. The experimental results show that the SDIV of epoxy resin under VLF voltage is lower than that at 50 Hz, while PTFE exhibits a similar SDIV under different frequencies. Both insulation materials exhibit significantly lower BDV at VLF compared to those at 50 Hz. As the pressure decreases, both the SDIV and BDV decrease. Furthermore, we have analyzed how pressure and frequency affect surface discharge in insulation boards, by means of the equivalent capacitance-resistance model and ion transport model. This study provides a reference for the insulation design of high-voltage power supplies for VLF communication equipment under low-pressure conditions.